How to use a portable permanent magnetic pump for flood drainage
The use of portable permanent magnetic pumps can be divided into the following steps to ensure that they can safely and effectively carry out drainage work:
1. Preparation before operation
Check the power connection:
Make sure that the power connection of the pump is correct and stable, and the cable is not damaged.
Check whether the power supply voltage is consistent with the rated voltage of the pump to avoid damage to the pump due to excessive or low voltage.
Check the status of the pump:
Check whether the mechanical seal of the pump is intact. If there is wear or aging, it should be replaced in time.
Check whether the appearance of the pump is damaged or cracked to ensure that the pump body is intact.
Check whether the foundation of the pump is stable to ensure that the pump will not shake or shift during operation.
Clean up debris:
Remove debris around and inside the pump to ensure that there are no obstacles affecting the normal operation of the pump.
2. Installation and connection
Choose an installation location:
Choose a solid and stable place to avoid excessive vibration and noise.
The installation location should be far enough away from the water source and the pool to avoid noise interference.
Connect the inlet and outlet pipes:
Connect the inlet and outlet pipes to the water inlet and outlet of the water pump respectively.
Note that the interface should be sealed to prevent water leakage.
3. Operation steps
Preparation before starting:
Confirm that the inlet and outlet valves of the pump are in the open state to ensure that the liquid can flow smoothly through the pump body.
Close the outlet valve of the pump, turn on the power switch, and start the motor of the pump without load.
Start and run:
Press the start button and the pump starts to operate normally.
Pay attention to whether the flow, pressure, temperature and other parameters of the pump are normal.
If there is any abnormality, the machine should be stopped immediately for inspection and troubleshooting.
Shutdown and shutdown:
After completing the drainage task, close the inlet valve of the pump first, and then turn off the motor.
Close the outlet valve to ensure that the liquid inside the pump is completely discharged.
4. Precautions
Follow the operating procedures:
Operate strictly in accordance with the operating procedures of the pump to avoid equipment damage or safety accidents caused by misoperation.
Regular inspection and maintenance:
Regularly inspect and maintain the pump to ensure its normal operation and service life.
For special or complex maintenance work, it is recommended to ask professionals to operate.
Pay attention to safety:
During operation, ensure the safety of personnel to avoid accidental injuries caused by vibration or high temperature of the pump.
Emergency treatment:
In case of sudden failure or emergency, the machine should be shut down and the power should be cut off immediately, and professional personnel should be contacted for repair in time.
Keep clean:
Regularly clean the dirt inside and outside the pump to keep it clean and prevent debris from clogging the flow channel.
