Solution to unstable water pressure of booster pump
Unstable water pressure in the booster pump is a common problem that may be caused by a variety of factors. Here are some common solutions to this problem:
1. Check and clean the pipes
Reason: Pipe blockage or foreign matter will affect the water flow, resulting in unstable water pressure in the booster pump.
Solution:
Regularly check and clean the inlet and outlet pipes of the booster pump to ensure that there are no blockages or foreign matter.
Use professional tools or chemical cleaners to clean the dirt and sediment in the pipes.
2. Adjust the balance of inlet and outlet water flow
Reason: The inlet and outlet pipes are not designed properly or the pipe diameters are inconsistent, resulting in unbalanced flow.
Solution:
Check and adjust the pipe diameter and length of the inlet and outlet pipes to ensure balanced inlet and outlet water flow.
Reduce unnecessary elbows and valves to reduce water flow resistance.
3. Check and replace booster pump parts
Reason: The internal parts of the booster pump, such as the reversing valve seal ring, gasket, etc., are damaged or aged, resulting in water leakage or performance degradation.
Solution:
Regularly check the wear of the internal parts of the booster pump and replace damaged parts in time.
Ensure that seals such as shaft seals and gaskets are intact to prevent water leakage.
4. Check and replace the pressure switch
Reason: The pressure switch is an important control component of the booster pump. If it fails, the water pressure will be unstable.
Solution:
Regularly check the sensitivity and accuracy of the pressure switch to ensure that it can normally control the working state of the booster pump.
If the pressure switch is found to be damaged or malfunctioning, a new pressure switch should be replaced in time.
5. Install pressure stabilizing equipment
Method:
Tap water pressure stabilizing pump: It can automatically start the pressure boost when the water pressure is lower than the set value to solve the problem of unstable water pressure. The specific installation method is to disconnect the main pipe behind the main valve of the tap water in the home, connect the tap water pressure stabilizing pump, and complete the power supply connection.
Tap water pressure stabilizing valve: A valve with a purely mechanical structure. Its main function is to prevent the harm caused by excessive water pressure. Although it cannot directly increase the water pressure, it can alleviate the problem of unstable water pressure to a certain extent. It is recommended to install it after the main valve at home.
Tap water pressure stabilizing tank: There is a rubber bladder inside, which can stabilize and buffer the water pressure according to the change of water pressure. When using, you need to consider the size of the pressure regulating tank and ensure that a one-way check valve is installed at the water inlet.
6. Consult a professional maintenance personnel
If the above methods cannot solve the problem, it is recommended to consult a professional booster pump maintenance personnel or contact the technical support team of the booster pump manufacturer to obtain a more professional solution.
