The stator of the G-type single screw pump is also called a rubber sleeve. The inner wall of the rubber sleeve is made of rubber material. Since the gap between the rubber sleeve and the rotor (screw) is small, the G-type screw pump is prohibited from idling and must have liquid for use. There is lubrication between the rubber sleeve and the screw shaft. During the rotation of the rotor (screw), friction will occur with the rubber sleeve. If the transported liquid contains fine hard particles, the service life of the rubber sleeve will be reduced. It is recommended to use abrasive liquids. Low speed screw pump. So to extend the service life of the rubber sleeve, you need to reduce the wear of the rubber.

As an important industrial pump, single screw pumps are widely used in various liquid transportation situations. However, during use, the problem of not being able to absorb liquid sometimes occurs, which seriously affects work efficiency. This article aims to explore the causes and solutions to this problem.

The stator of the G-type single screw pump is made of rubber and is a wearing part of the single screw pump. Its selection will directly affect the life of the stator. Under normal circumstances, the life of the stator is 3-6 months. If it is not selected properly, The stator may fall off the steel tube or the rubber may fall off.